next up previous contents
Next: Appendices Up: Mixing Model Components Previous: Suzpsf

·        xmmpsf: xmm surface brightness model

Mixing model for XMM data. Mixes the spectra between datagroups based on the PSF overlap between selected regions. A surface brightness model is required to calculate the mixing and this can be supplied in several ways. If XMMPSF-IMAGE has been set to some image file (using xset) then this image will be used for the surface brightness distribution. If XMMPSF-IMAGE has not been set then either a beta or two power-law model is used. In this case the model parameters determine the shape of the surface brightness distribution. If XMMPSF-RA and XMMPSF-DEC are set they are used as the center of the distribution. They should be specified either in decimal degrees or as hh:mm:ss.s and dd:mm:ss.s. If XMMPSF-RA and XMMPSF-DEC are not set then the centroid of the wmap will be used as the center of the surface brightness distribution.

The model works by calculating the mixing factors. It will recalculate these factors if any of the XMMPSF-* or any of the model parameters are changed. Calculating the mixing factors is very slow so should be avoided as much as possible.  To speed things up, it is possible to save the mixing factor array to a FITS file and re-use it during a later calculation.  To save a mixing factor calculation, prior to loading the mixing model (using the model command), use xset to set the variable XMMPSF-MIXFACT-OFILEn to the name of the output FITS file, and where n is an integer corresponding to the observation number:

 

XSPEC12> xset XMMPSF-MIXFACT-OFILE1 fact_obs1.fits

 

Conversely, a saved factor array can be read in by setting XMMPSF-MIXFACT-IFILEn:

 

XSPEC12> xset XMMPSF-MIXFACT-IFILE1 fact_obs1.fits

 

Multiple observations can be fit simultaneously. In this case the observations should be read in each datagroup in the same order, e.g.

 

XSPEC12> data 1:1 obs1reg1 1:2 obs2reg1 1:3 obs3reg1 2:4 obs1reg2 2:5 obs2reg2

 

par1

Alpha (not used if Switch=0

par2

Beta

par3

Core (arcmin)

par4

Switch (0 = beta model, 1 = 2-power-law)

 

 

 

                                        

next up previous contents
Next: Appendices Up: Mixing Model Components Previous: Suzpsf